Jump directly to main navigation Jump directly to content
Go back

Drill bit holder for punching dies

For larger punching operations or certain types of material, using a low-speed column drill press is a sensible alternative to knocking out the material. In this case, the process is more of a cutting action. This method is particularly recommended for soft, springy materials such as rubber, etc.

The speed of the column drill press must be adjusted to the material.

The photo above shows the two methods. For sets with a holding disc for the punches—sets ranging from 2 to 50, 59, or 60 mm—a drill press adapter for the holding disc is available. For punch sets up to 30 mm that also hold the punches, a drill press adapter similar to the cylindrical impact handle with a 10 mm shank is available. Both holders have a cylindrical drill chuck adapter with a diameter of 13 mm or 10 mm, respectively.

The photo taken in the field shows the holder being used for sets up to 30 mm. Please keep this in mind when ordering.
The current holder for sizes up to 30 mm is shorter than shown in the photo.

Please also note our die-cutting mat for optimal, clean cuts, even in thin materials.

Product variants
Part number
Net price
Gross price
Quantity
Drill holder for punch sets from 50 mm with shank diameter 13 mm
87055
53,80 €
64,02 €
Drill holder for punch sets up to 30 mm with shank D=10 mm
87005
55,80 €
66,40 €